Here’s the 1940s Regal X brace conversion that I finished up earlier this winter. I’ve finally managed to convince my daughter to let me take it back! The guitar started as a ladder-braced instrument with Regal’s ‘Small Jumbo’ body that measures 15.5″ at the lower bout and has a fairly deep body depth. It’s a […]
Read moreIn this video Mark discusses some of the unique construction details of an early sunburst 14 fret L-00 from 1933. An L-00 isn’t just an L-00… there’s always more than meets the eye!
A clean brace reglue is all about taking the time to set things up precisely. Gibson brace ends are notorious for popping loose, and getting them back down again can take some real coaxing.
In the case of this early ’50s J-45, the shrinking pickguard had cupped the top so badly that the upper soundhole brace, X brace, and a finger brace were all loose from the top and tightly sprung. The pickguard was removed, the top ‘ironed’ flat, and the braces are now getting reglued one-by-one.
It’s not uncommon to need to make custom brace-end gluing cauls that are specific to the guitar being worked on. It’s a lot of extra work, but a well-fit caul is critical to a clean end-result and a repair that will hold in the long run.
Custom brace-end caul
Mark offers some thoughts on cracks in the tops of vintage guitars. You’ll learn why they happen, which ones are more concerning than others, how to spot them, and what to do about them.
This kind of bridgeplate positioning is a regular sight in a 50’s Gibson.
Someone didn’t like their job all too much, I figure.
A lifetime later, these sort of idiosyncrasies are partially responsible for the tonal variation between otherwise similar Gibson flat tops.
This is a 1951 J-45 that’s on the bench for a neck reset and some requisite brace regluing.
Mark discusses the unique 1932 Gibson L-00 with 13-fret neck joint, and the specific considerations that went into its repair.
Nightshift guitar repair going on here with a 1933 Martin R-18 on the bench – the little sibling of Martin’s C-1 archtop.
Unlike the carved C-1, the R-18 has a pressed top that is just a bit thicker than a normal flattop top and features a beefed up X flattop style X bracing, complete with a little maple bridgeplate.
It is interesting to compare this model with Gibson’s flattop guitars that featured trapeze tailpieces and archtop-style bridges at around the same time.
Both Martin and Gibson were trying out bold new ideas in the early days of steel string guitar-making in the late 20’s and early 30’s.
Some top crack repairs are more involved than others. This is the Sat-on-at-a-party-long-before-Covid 1947 LG-2. Still a long, long way off from completion, but a little bit closer now.
Nothing terribly fancy going on here, but I think it looks interesting enough to share. The top cracks are being glued while the simple wedge system is pushing everything together; the clamps and 25 lb sandbag are keeping things properly aligned. The treble-side crack was done yesterday. It follows the grain at the outside edge of the pickguard to within 2” of the top, and all the way to the bottom of the plate.